About & how this site is built

Who

Built and owned by Jeremy Panasuk, New Auburn, Wisconsin. Contact: [email protected]. Jeremy is a data/software person, not a licensed certified welding inspector or welding engineer. These are planning tools, not professional advice.

How

The calculators use published rules of thumb from the sources listed on each page. Page text is drafted with AI agents (Cursor and local models) from those sources. Formulas are checked against the cited sources. If you spot an error, email [email protected] and it gets fixed. How the formulas, sources, and corrections are handled is on the methodology page.

Why

The site earns money from Amazon affiliate links. That doesn't change the math.

Sources & Standards

Solid-wire MIG starting points on this site follow the Miller page below: 1 amp per .001 inch of steel, and the wire-speed multipliers.

Miller Electric, MIG Welding: Setting the Correct Parameters

Frequently asked questions

Is this calculator free?

Yes — free to use, no signup, no email required.

How accurate is the estimate?

Estimates follow industry-standard sizing rules and common safety margins. Always confirm with a licensed professional for final sizing.

Can I use this on mobile?

Yes — the page is fully responsive and works on phones, tablets, and desktop.

Where does the math come from?

Formulas are shown inline on the result panel so you can verify each step yourself.